User's Manual Part 2

Connecting Contact Alarms to a Fusion Wideband System
InterReach Fusion Wideband Installation, Operation, and Reference Manual Page 157
D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013 © 2013 TE Connectivity Ltd.
AlarmSource
FusionWidebandalwaysactsasanalarmsource,nomatterwhattypeofequipmentyouare
connectingto.Referto“AlarmSense”onpage160ifyouwantFusionWidebandtosenseUnison
contactclosuresorother
externalalarms.
NOTE: Thefollowing proceduresassu methat thesystem is installedand that hasbeen programmed
withbands.
UsingFlexWaveFocustoMonitorFusionWideband
WhenyouconnectFlexWaveFocustotheFusionWideband,theFusionWidebandMainHubis
theoutputofthealarms(alarmsource)andFocusistheinput(alarmsense),asshownin
Figure46.Focussupportsonlyfaults(majorerrors).
Figure46.
Connecting FlexWave to Fusion Wideband
Band 1 Band 2 Band 3
UL1 UL2 UL3
Alarms
DL1 DL2 DL3
AC Power
Band 1 Band 2 Band 3
UL1 UL2 UL3
Alarms
DL1 DL2 DL3
AC Power
Fusion Main Hub
May need
9-pin Adapter
that ships
with the cable
Alarm
Sense
5-port Alarm Daisy-Chain Cable
Alarm
Source
Alarm
Source