User's Manual Part 2

Installing Fusion Wideband
Page 156 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2013 TE Connectivity Ltd D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013
CONNECTINGCONTACTALARMSTOAFUSIONWIDEBANDSYSTEM
TheFusionWidebandMainHubcangenerate(source)twocontactalarmsaswellassensethree
externalcontactalarm.
• AlarmSource—TheFusionWideban
dMainHubhastwoalarmcontacts,fault(major)and
warning(minor).Thesecontactsarenormally‐closed(NC)andwillopenwhenaninternal
alarmisdetected.Forfurtherinformation,see“AlarmSource”onpage157.
NOTE: The contact can be changed to normally‐open (NO) with AdminBrowser. This is not
recommendedsincenoalarmwouldbesentifpowertotheFusionWidebandMainHubfails.
– Faultisactivatedwhenanyfaultsordisconnectsaredetected.
– Warningisacti
vatedwhenanywarningconditionsaredetectedexceptlockoutorwhen
theend‐to‐endsystemtestisnotvalid.
• AlarmSense—The
FusionWidebandMainHubcanmonitor3externalalarmcontacts.Each
portcanbeconfiguredfornormally‐open(NO)ornormally‐closed(NC)contacts.The
interfaceexpectsasetoffloatingcontacts,andanexternalvoltagesourceisnotrequiredfor
thisinterface.UseAdminBrowsertomonitortheportstatus.Forfurtherinformation,see
“A la r m  S e n s e ”  o n  p a g e  1 6 0 .
Table90liststhealarmtypes,equipmenttowhichtheFusionWidebandMa
inHubisconnected,
cable(s)used,andthefaultsand
warningsthataredetected.
NotethatFlexWaveFocussupports
onlyfaults(majorerrors).
Table90
. AlarmTypes
Alarm
Type
Fusion Wideband
Connected to
Cable(s) Used Errors Detected
Source FlexWave 5-port Alarm Daisy-Chain Cable Faults
Source BTS 5-port Alarm Daisy-Chain Cable Faults and Warnings
In addition, a custom daisy-chain cable-to-BTS interface cable
is required. Make
this interface cable to the desired length and
with the appropriate pin placement.
Sense Unison 5-port Alarm Daisy-Chain Cable
an
d the Alarm Sense Adapter Cable
Faults