User's Manual Part 2

Installing Fusion Wideband
Page 144 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2013 TE Connectivity Ltd D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013
15 IntheInput/OutputAlarmspanel,dothefollowingforeachAlarmSense:
• Ena
bleeachAlarmSensebyusingthecheckbox.
• Usethepull‐downtosettheNormalStatetoClosedorOpened.(Thedefaultis“Clo
sed.”
• Assigna
labeltoeachalarmsense.
16 Wh
enyouhavecompletedinputtingthedesiredinformation,clickInstall System toconfigure
thesystem.
Duringconfigurationalldisconnectstatusesa
reclearedforattachedRAUs;thefrequency
band,gain,andsystemlabelareset;logsarecleared;thesystemtestisperformed;andfinally
thesystemtreeisrefreshed.Theiconsshouldbe:
Ifthereareproblems,theiconswillbe
differentandamessageisdisplayedintheMessages
pane.
17 ConnecttheMainHubtotheRF
source(forexample,BTSorBDA).
CAUTION! Do not exceed the maximum  input RF power (1Watt) to the Fusion Wideband Main Hub.
ExceedingthelimitcouldcausepermanentdamagetotheHub.
CAUTION! Onlycarrie
rsandtheirapprovedinstallersorTE‐authorizedinstallersar eallowedtoconnectto
theRFsource.Seriousdamagetotheequipmentcanoccurifitisover‐driven.
TheFusionWidebandsystemshouldnowbeoperational.Usingamobilephone,walkyour
siteandtestthesignalstrength.
18 Make
suretochangetheTCP/IPsettinginyourlaptopbacktotheiroriginalvalues.
NOTE: TEequipmentisdesignedtooperateinthelicensedfrequencybandsofmobileoperators.Inthe
USA,theEU,andmostcountriesthisequipmentmayonlybeusedbythelicensee,hisauthorized
agentsor thosewith writtenauthorization todo so.Similarly,unauthorizeduseisillegal,and
subjects the owner to the  corr
esponding legal sa nctions of the national jurisdiction involved.
OwnershipofTEequipmentcarriesnoautomaticrightofuse.
Indicates that the band is correctly set on the Main Hub.
Indicates that the band is correctly set on the Expansion Hub.
Indicates that communications are OK.