User's Manual Part 2

Table Of Contents

Installing Fusion Wideband

Page 116 InterReach Fusion Wideband Installation, Operation, and Reference Manual

Usethescrewsprovidedtofastenthecablemanagertotherack,immediatelyaboveorbelowthe

MainHub.

NOTE: Themaximumweightthebracketcanholdis22.5kg(50lbs).

NOTE: Thebra

cketisdesignedtoaccommodate aFusionWidebandMainHub(12lbs.)oranExpansion

Hub(14.5lbs.).

NOTE: Thewallmo

untbracketshouldbesecurelymountedtowall,usingthefourkeyslotmounting

holesonthebracket.

NOTE: Thera

ck‐mountingbracketsontheFusionWidebandMainHubmustbemovedtotherecessed

mountingposition(shownin Figure22)toallowfo

rtherequired76mm(3in.)rearclearance.

1 Attachthewallbracket(PN4712)towalltheusing#10PanHeadwoodscrews,1‐1/2”

minimumlengthformountinginwoodstudsor3/4“thickplywood.Thebracketmustbe

positionedsothattheHubwillbeinahorizontalpositionwhenitisinstalled.(Referto

Figure22.)

NOTE: Ifwall studspacingof16”is notavailable, pre‐install3/4 ” plywood to thewall.Youcanthen

attachthebrackettotheplywoodusingthewoodscrews.

Figure22.Bracket Detail For Wall Mount Rack (PN 4712)

2 RemovebothoftherackmountingbracketsfromtheHub.

3 Reattacheachoftherackmounting

bracketstotherecessedwallmountposition.

4 InstalltheHubintherackusingt

herackmountingscrews.

 InstallinganOptionalCableManagerintheRack

 InstallingaMainHubUsingthe12”Wall‐MountedRack(PN4712)