User's Manual Part 1

Remote Access Unit
Page 58 InterReach Fusion Wideband Installation, Operation, and Reference Manual
© 2013 TE Connectivity Ltd D-620616-0-20 Rev H • TECP-77-044 Issue 7 • May 2013
RAULEDINDICATORS
Uponpowerup,theRAUgoesthroughatwo‐secondtesttochecktheLEDlamps.Duringthistime,
theLEDsblinkgreen/greenred/red,lettingyouvisuallyverifythattheLEDlampsandthe
firmwarearefunctioningproperly.
NOTE: Refer to “Maintenance, Troubleshooting, and Technical Assistance” on page181 for
troubleshootingus
ingtheLEDs.
StatusLEDs
TheRAUstatusLEDscanbeinoneofthestatesshowninTable5‐3.TheseLEDscanbe:
Steady green
Steady red
Off
Table 0-1 Remote Access Unit LED States
LED State Indicates
Off
Off
The RAU is not receiving DC power.
Green
Green
The RAU is powered and is not indicating a fault
condition.
Communication with the Fusion Wideband
Hub is normal; however, the system test may need to
be performed or a warning condition may exist (use
AdminBrowser to determine this).
Green
Red
The RAU is indicating a fault
or lockout condition, but
communication with the Fusion Wideband Hub is
normal.
Red
Red
The RAU is reporting a fault and is not able to
communicate with the
Fusion Wideband Hub
Green (60-ppm)
Green (60-ppm)
The RAU is reporting a lockout condition, but
communication with the Fusion Wideband Hub is
normal.
LINK
ALARM
LINK
ALARM
LINK
ALARM
LINK
ALARM
LINK
ALARM