User's Manual

Help Hot Line (U.S. only): 1-800-530-9960 8-5

D-x620610-0-20 Rev D CONFIDENTIAL

Replacing a Fusion Main Hub

10. Click SYSTEM CONFIGURATION and click on SETUP NETWORK CONNECTION OR

ODEM CONNECTION if the Main Hub has Network or Modem equipment con-

nected to it.

During System Test, the entire system is temporarily off-line and no RF is

being transmitted.

Checking the Main Hub’s LEDs

• The LEDs should blink through a 5-second test on power up.

• If the LEDs do not blink on power up, replace the Main Hub.

• If the LEDs do not illuminate at all, make sure the AC power cable is con-

nected.

• For each fiber optic port that has a connected Expansion Hub, which has been pro-

grammed with a band, the

PORT LED should be green.

• Refer to Section 9.3.2, “Troubleshooting Using LEDs,” on page 9-5 for more LED

states.

NOTE: If there is no communication between the Main Hub and the Expansion

Hubs, use the AdminBrowser to isolate system problems.