Installation Manual

ADCP-75-112 • Issue 2A • June 2001
Page 15
© 2001, ADC Telecommunications, Inc.
Fig 12-A
DRILL HOLES THROUGH
PLASTIC COVER ONLY.
SEE REAR SIDE FOR
HOLE LOCATIONS.
USE APPROPRIATE
FASTENERS FOR
WALL SURFACE
NOTE: TO COMPLY WITH MAXIMUM
PERMISSIBLE EXPOSURE (MPE) REQUIREMENTS,
ANTENNAS MUST BE INSTALLED TO PROVIDE AT
LEAST 20 CENTIMETERS OF SEPARATION FROM
ALL PERSONS PER FCC 47 CFR PART 2.1091.
MAKE SURE ARROW ON REAR
SIDE OF ANTENNA IS POINTING
UP WHEN ANTENNA IS MOUNTED
5/8-INCH (16 mm) HOLE
FOR ANTENNA CABLE
TO BE COMPLETED
WHEN DRAWING
IS AVAILABLE
Figure 12. 1900 MHz Directional Panel Antenna Installation
2.5.6 800 MHz 90º Panel Antenna
The 800 MHz 90º panel antenna is designed to mount vertically in the corner of the coverage
area. Mount the 90º panel antenna as shown in Figure 13 and as described in the following
procedure:
1. Loosen base assembly handle until antenna can be separated from base assembly.
2. Place base assembly against wall near corner and drill holes in wall for fasteners
(installer provided).
3. Secure base assembly to wall with fasteners.
4. Drill 5/8-inch (16 mm) hole in wall for antenna cable.
5. Insert antenna cable through hole in wall.
6. Reinstall antenna on base assembly.
7. Direct antenna toward center of coverage area and tighten base assembly handle.
8. Route antenna cable to DRU.