Installation Manual

ADCP-75-112 • Issue 2A • June 2001
Page 14
© 2001, ADC Telecommunications, Inc.
16246-A
DRILL HOLES THROUGH
PLASTIC COVER ONLY.
SEE REAR SIDE FOR
HOLE LOCATIONS.
USE APPROPRIATE
FASTENERS FOR
WALL SURFACE
NOTE: TO COMPLY WITH MAXIMUM
PERMISSIBLE EXPOSURE (MPE) REQUIREMENTS,
ANTENNAS MUST BE INSTALLED TO PROVIDE AT
LEAST 20 CENTIMETERS OF SEPARATION FROM
ALL PERSONS PER FCC 47 CFR PART 2.1091.
MAKE SURE ARROW ON REAR
SIDE OF ANTENNA IS POINTING
UP WHEN ANTENNA IS MOUNTED
5/8-INCH (16 mm) HOLE
FOR ANTENNA CABLE
Figure 11. 800 MHz Directional Panel Antenna Installation
2.5.5 1900 MHz Directional Panel Antenna
The 1900 MHz directional panel antenna is designed to mount vertically on one side of the
coverage area. Mount the directional panel antenna as shown in Figure 12 and as described in
the following procedure:
1. Drill holes in antenna plastic cover for fasteners (see rear side for hole location).
2. Drill 5/8-inch (16 mm) hole in wall for antenna cable.
3. Insert antenna cable through hole in wall.
4. Place antenna on wall, making sure arrow on rear side of antenna points up.
5. Drill holes in wall for fasteners (installer provided).
6. Secure antenna to wall with fasteners.
7. Route antenna cable to DRU.