User's Manual

ADCP-75-198 • Issue 1 • October 2005
Page 12
© 2005, ADC Telecommunications, Inc.
3.4 Modular Optical Transceiver Installation
Modular optical transceivers are available separately and may or may not be installed in the SDR
PCIx Host Card depending on the configuration ordered. If optical transceivers are factory
installed in the SDR PCIx Host Card, skip this section and proceed to
Section 3.3.2 Optical
Connections on page 9
. If optical transceivers are not factory installed, use the following
procedure to install each transceiver:
1. Slip on an ESD wrist strap and connect ground wire to an earth ground source. Wear ESD
wrist strap while completing optical transceiver installation procedure.
2. Locate the appropriate transceiver socket on the front of the SDR card as shown in
Figure 5 and remove the cover from the socket.
Figure 5. Optical Transceiver Installation
Warning: Electronic components can be damaged by static electrical discharge. To prevent
ESD damage, always wear an ESD wrist strap when handling electronic components.
19312-A
TYPE A
TRANSCEIVER
TYPE B
TRANSCEIVER
TYPE C
TRANSCEIVER
RELEASE
LEVER
RELEASE
TAB
RELEASE
BAR
DUST
CAPS