User's Manual Part 9

Remote Displays Section 7
Element Management System (EMS) 4.0 User Manual
90
4.5.7 Remote Config Window
The remote Config (Configuration) window, shown in Figure 79, shows the site
number of the identified host/remote pair and the site name of the remote unit.
This window also identifies the EMS module type and subtype for use in
identifying the system to ADC support personnel.
Figure 79. Remote Config Window
Clicking on the Edit button for Site Name causes a dialog window to be
displayed. The dialog window can be used to enter or edit a site name for the
remote unit. For further instructions on entering a site name, refer to Topic Topic
3.7, Entering Host/Remote Site Numbers and Site Names, on page 36.
NOTE: The remote unit shares a site number with its paired host unit.The host/
remote site number can be edited using the host Config window.
Reflasher Remote Reprogram Program version
Control Program Remote Control Program version
FPGA Program Field Programmable Gate Array version. If the unit is an
older type with a non-replaceable array, this field will
identify the version as “UNKNOWN.”
Table 33: Prg Load Window Components (Continued)
DISPLAY NAME DESCRIPTION