User's Manual Part 9

Commands Section 9
Element Management System (EMS) 4.0 User Manual
110
You can also use this command to turn off the POST MESSAGE display, for a
specific network element or for all network elements, by setting the time interval
to zero.
To set the POST MESSAGE period for a network element
1. Enter a command in the following format
DEMS Site_Name SET POST mm:ss
(or)
DEMS Node_Number SET POST mm:ss
where Site_Name is the site name of the network element, Node_Number
is the Host Node or Remote Node value (as displayed in the Maintenance
interface View Catalog window), and
mm:ss is the desired setting in min-
utes and seconds. Use Site_Name = ALL to set all network elements at
the same time.
2. Look for a response like this
1130 23-Mar-01 DEMS(35 Host.11)SteeleCenter SET POST 15:00 \
15:00 \
END
where the value 15:00 in the example indicates that the posting interval has
been set to 15 minutes and zero seconds.
Examples
DEMS WasecaWallMart SET POST 15:00
DEMS ALL SET POST 25:00
To turn off the POST STATUS message
1. Enter a command in the following format
DEMS Site_Name SET POST 00:00
(or)
DEMS Node_Number SET POST 15:00
2. Look for a response like the previous example with all network elements set
to the time period
15:00.