User's Manual Part 9

NOC-NEM Interface Commands
Element Management System (EMS) 4.0 User Manual
105
5.5.7 GET DATA
This command can be used to display the current values for a named parameter on
an identified network element or for all network elements. You can identify the
network element using site name or node number.
To query for current parameter values
1. Enter a command in the following format
DEMS Site_Name GET DATA Parameter_Name
(or)
DEMS Node_Number GET DATA Parameter_Name
where Site_Name is the site name of the network element, Node_Number
is the Host Node or Remote Node value (as displayed in the Maintenance
interface View Catalog window),
Parameter_Name is the software name
of the parameter being queried. Use
Site_Name = ALL to query for all net-
work elements. Use
Parameter_Name = ALL to query for all parameters.
The following host unit parameter names can be entered:
Temp, 8Volt,
3p8Volt. The following remote unit parameter names can be entered:
PsBattVolt, Temp, 8Volt, 3p8Volt, RFOutPwr, RFRflPwr,
and
CurrVSWR.
2. Look for a response like this:
1130 23-Mar-01 DEMS 48 GET DATA DCVoltLvl \
DCVoltLvl 25.8 \
END
3. Interpret the response as follows: The second line returned identifies the
parameter and gives its current value (
25.8 in the example shown).
Sec Rev Synth Lock SecRevSyn
LPA Fan LpaFan
LPA High Temp LpaTemp
Minor Extern Alarm Nonexisting
Table 38: Remote Minor Alarms (Continued)
MAINTENANCE INTERFACE NAME NOC-NEM NAME