User's Manual Part 9

Element Management System (EMS) 4.0 User Manual
93
The EMS Network Operations Center–Network Element Manager (NOC-NEM)
Interface allows you to communicate with EMS remotely using the commands
specified in this section. You can also enter the same commands using the NOC-
NEM window in the Maintenance Interface.
5.1 Summary of Tasks and Commands
Table 34 lists the main tasks that can be done in NOC–NEM and tells where to get
instructions for each task (NE = network element).
Table 34: Main Tasks and Commands
POSSIBLE TASK COMMAND SEE TOPIC
List all NEs currently connected GET CATALOG 5.5.1 on page 96
Assign a site name to an NE SET SITENAME 5.5.3 on page 98
Determine current status of one or all NEs GET STATUS 5.5.8 on page 106
Display a summary of alarm states GET ALARMSUMMARY 5.5.2 on page 97
Display alarm detail for one or all NEs
GET ALARM 5.5.6 on page 101
Find what software is loaded on an NE GET SWINFO 5.5.5 on page 100
View or set POST STATUS time interval
or turn off POST STATUS messages
GET POST
SET POST
5.5.11 on page 109
5.5.12 on page 109
View or set time interval for recording NE
status in EMS log file
GET RECORD
SET RECORD
5.5.9 on page 106
5.5.10 on page 108
Display recorded status for one or all
NEs; set a time range to limit output
GET PLAYBACK
SET PLAYBACK
5.5.13 on page 111
5.5.14 on page 111
Determine or define whether an alarm is
shown in POST STATUS messages
GET ALARMFILTER
SET ALARMFILTER
5.5.15 on page 112
5.5.16 on page 113
View or set attenuation for RF analog sig-
nal transmitted from remote unit antenna
GET THRESHOLD
SET THRESHOLD
5.5.17 on page 114
5.5.18 on page 115
NOC-NEM
I
NTERFACE