User's Manual Part 8

Host Displays Section 7

Element Management System (EMS) 4.0 User Manual

4.4.4 Host DC Pwr Window

The host DC PWR (DC Power) window, shown in Figure 65, contains dashboard

displays with readings from the temperature sensor and voltage supply sensors on

the host unit control board. Table 17 describes the dashboard displays.

Sec Rx Errors Multiple errors on secondary fiber. Error rate has

exceeded 10

–6

(one bit error per million bits).

Table 14: Host Synthesizer and Band Alarms When Faulted

ALARM NAME DESCRIPTION

Pri Fwd Mux Lock The forward path primary fiber phase-locked-loop is

out of lock.

Ref Synth Lock The reference synthesizer is out of lock.

B Laser Mux Fault The secondary fiber phase-locked-loop is out of lock.

Table 15: FPGA Alarm When Faulted

INDICATOR NAME DESCRIPTION

Host FPGA Fault Fault was reported in FPGA chip on Host PCIx Card.

Table 16: Host Band Indicator

INDICATOR NAME DESCRIPTION

Band Indicates the RF bandwidth and sub-band at which this

unit is running. If the host unit and remote unit are at

different bands, a Hardware Mismatch alarm is

reported (for more information, see Topic 4.4.1, Host

Alarms Window, on page 69).

Table 13: Host Optics Alarms When Faulted (Continued)

ALARM NAME DESCRIPTION