User's Manual Part 7

EMS Pull-Down Menus Section 7
Element Management System (EMS) 4.0 User Manual
60
The View menu is built at start up and rebuilt whenever calaloging is requested by
a user selection of Tools
ÞRefresh Catalog. Table 5 describes the selections
available on the View menu.
4.1.4 Tools Menu
The Tool s menu, shown in Figure 51, has three items, Refresh Catalog,
Opmode, and Host Adapt.
Table 5: View Menu Items
MENU ITEM DESCRIPTION
Catalog This item is always present. Selecting it causes EMS to look
for and identify all network elements connected and known.
Selecting this item also causes the View menu to be rebuilt.
For Catalog display, see Topic 4.2 on page 65.
Alarm Overview This item is always present. Selecting this item displays an
alarm summary with a an alarm status indicator for each
known network element and an alarm history indicator for
each alarm that has not been acknowledged. The Alarm
Overview is described in Topic 4.3 on page 66.
NotNamed/NotNamed This item is only present if a host/remote pair seen by EMS
have not yet been given site names. You should assign site
names as described in Topic 3.4 on page 31.
<SiteName/SiteName> (“Askov/Tower,” for example) displays the selected host/
remote pair alarm windows. From the alarm windows you
can select from the listed information tabs including:
• For the Host Unit: Alarms, RF, Host, DC
Pwr, Ext Alm, Prg Load, and Config (see
Topic 4.4, Host Displays, on page 69).
• For the Remote Unit: Alarms, RF, STM,
DC Pwr, Ext Alm, Prg Load, and Config
(see Topic 4.5, Remote Displays, on page
80).