User's Manual Part 5

Setting Operating Mode Section 3
Element Management System (EMS) 4.0 User Manual
48
7. Click in the Rev RF Chnl Gain field to display a pulldown list. Select the
item for the desired amount of signal gain. The range of possible values is
from 10 to
−20 dBm. The standard value for this field is 0.
8. If the remote unit supports the diversity option (second reverse path), click on
the Div RF Chnl Gain field to display the pulldown list. Select the item for
the desired amount of signal gain. The range of possible values is from 10 to
−20 dBm. The standard value for this field is 0.
9. Use the last field on the right, RF Chnl Enable, to enable the channel if it will
go into immediate use. To enable the channel, click on the field to set the dis-
played value to “true.” If the channel should not be enabled at this time, let it
stay at the value “false.” When a value is changed in this field, a box appears
temporarily as shown in Figure 40.
Figure 40. Setting Channel Enable
10. When done, exit the window to proceed with other tasks if desired.
To do this same task using the NOC-NEM interface
You cannot use NOC-NEM to perform these tasks.
3.13 Setting Operating Mode
A host/remote pair has three user-selectable operating modes plus two modes that
happen automatically when a program file is downloaded. User-selectable modes
can be started or stopped using the OpMode window, shown in Figure 41.