User's Manual Part 1

ADCP-75-187 • Preliminary Issue 1B • November 2005 • Section 2: DESCRIPTION
Page 2-13
© 2005, ADC Telecommunications, Inc.
Figure 2-6. Interim Single-Band and Dual-Band Remote Unit User Interface
Table 2-4. Interim Single-Band and Dual-Band Remote Unit User Interface
REF
NO
USER INTERFACE
DESIGNATION
DEVICE
FUNCTIONAL
DESCRIPTION
1 BAND 1 OptiTap APC/SC
connector (angled
single-mode)
Input/output connection point for the BAND 1
(see tag to identify system) combined forward
and reverse path optical fiber. The host unit must
be equipped with a WDM.
2 BAND 2 (Interim
single band unit)
Unused OptiTap
connector
Band 2 optical port not used with the interim sin-
gle-band version of the RU.
BAND 2 (Dual-band
unit)
OptiTap APC/SC
connector (angled
single-mode)
Input/output connection point for the BAND 2
(see tag to identify system) combined forward
and reverse path optical fiber. The host unit must
be equipped with a WDM.
3 Threaded hole with
hex socket screw
Connection point for the grounding wire.
4 ANT N-type female RF
coaxial connector
Connection point for the antenna cable.
5 No designation Red LED
(off/red)
Indicates if the RU is powered and normal (off)
or if a major fault is detected (red). See Note.
6 POWER Mini 3-wire AC
power connector
Connection point for the AC power cord.
Note: A more detailed description of the LED operation is provided in Section 4.
20976-A
(1) BAND 1 OPTICAL PORT
(USED WITH INTERIM SINGLE-
BAND AND DUAL-BAND UNIT)
(2) BAND 2 OPTICAL PORT
(NOT USED WITH INTERIM
SINGLE-BAND UNIT)
(3) GROUNDING LUG
CONNECTION POINT
(4) N-TYPE CONNECTOR
FOR ANTENNA
(5) LED
INDICATOR
(6) AC POWER
CONNECTOR