User's Manual

ADCP-75-210 • Issue 1 • November 2006

Page 31

2.2 Unpacking and Inspection

The RAN is shipped to the field pre-configured with all modules and components that the

customer has ordered. Electronic modules except for the batteries are shipped already installed

in the cabinet.

The following optional accessories may also be shipped with the RAN:

• Back-up batteries

• Non-standard SFP optical transceiver

Use the following procedure to unpack and inspect the RAN components:

1. Open the shipping cartons and carefully unpack each component from the protective

packing material.

2. Check each component for broken or missing parts. If there are damages, contact ADC for

an RMA (Return Material Authorization) and to reorder if replacement is required. For

contact information, refer to Section 6 on Page 72.

2.3 Required Materials and Tools

The following materials must be supplied by the installer:

• (Pole mount only) Three galvanized steel square headed bolts with minimum tensile

strength of 20,050 lbs., 3/4 in. diameter, and of a length appropriate to pole diameter;

Three nuts for bolts, three flat washers, three split ring washers, and three 3-in. square

curved washers (see Figure 26 on Page 39)

• (Pad mount only) Four 1/2 in. diameter galvanized steel bolts with four lock washers, four

flat washers, and four concrete anchors (see Figure 28 on Page 41)

• 3M 8426-9M cold shrink

• 3M Skothkote Electrical Coating 14853

• Ten Type N plugs (CommScope PN: 540ANM or equivalent)

• Coaxial cable (CommScope PN: FXL540OPE or equivalent)

• Electrician’s tape

• Water seal

• Electrical conduit

• Conduit fittings

• Connector sealant material

• Panduit LLCF6-14B-L or equivalent (X2)

• Two-hole compression lug terminal for #6 AWG wire

• Ground rod

• Connector for attaching #6 AWG grounding wire to approved ground source