User Manual

ADCP-75-159 • Issue 1 • August 2003 • Section 5: Maintenance

Page 5-18

Figure 5-5. STM Fan/Grill Assembly Removal

7. Carefully withdraw the fan/grill assembly from the STM housing until the wiring harness

is exposed and the connector is accessible.

8. Lift the small latch on the wiring harness connector and carefully unplug the connector

from the circuit board connector.

9. Remove the plastic rivets that secure the fan to the mounting plate and grill by pushing

outward on the rivet center post until the rivet can be withdrawn as shown in Figure 5-6.

Figure 5-6. Removing STM Fan From Mounting Plate and Grill

16992-A

16993-A