User Manual

ADCP-75-159 • Issue 1 • August 2003 • Preface

Page ix

STANDARDS CERTIFICATION

FCC: This equipment complies with the applicable sections of Title 47 CFR Part 90.

UL/CUL: This equipment complies with UL and CUL 50 Standard for Enclosures for

Electrical Equipment. This equipment provides the degree of protection specified by IP43 as

defined in IEC Publication 529.

FDA/CDRH: This equipment uses a Class 1 LASER according to FDA/CDRH Rules. This

product conforms to all applicable standards of 21 CFR Part 1040.

IC: This equipment complies with the applicable sections of RSS-131. The term “IC:” before the

radio certification number only signifies that Industry Canada Technical Specifications were met.

LIST OF ACRONYMS AND ABBREVIATIONS

The acronyms and abbreviations used in this manual are detailed in the following list:

AC Alternating Current

ASCII American Standard Code for Information Interchange

Att Attenuation

AW G American Wire Gauge

BER Bit Error Rate

C Centigrade

CAN Controller Area Network

CDRH Center for Devices and Radiological Health

CD-ROM Compact Disk Read Only Memory

COM Common

Config Configuration

CUL Canadian Underwriters Laboratories

CWDM Coarse Wavelength Division Multiplexer

DC Direct Current

DCE Data Communications Equipment

DTE Data Terminal Equipment

EBTS Enhanced Base Transceiver Station

EIA Electronic Industries Association

Warning: The HU is powered by 48 VDC power which is supplied over customer-provided

wiring. To prevent electrical shock when installing or modifying the HU power wiring,

disconnect the wiring at the power source before working with uninsulated wires or terminals.

Caution: Always allow sufficient fiber length to permit routing of patch cords and pigtails

without severe bends. Fiber optic patch cords or pigtails may be permanently damaged if bent

or curved to a radius of less than 2 inches (50 mm).