User's Manual

ADCP-75-158 • Issue 1 • July 2003 • Section 2: Description

Page 2-14

4.5 Antenna Cable Connections

The antenna cable should be routed to the indoor mounting shelf for connection to the STM

module. If lightning protection is required, it is recommended that a lightning protector

(accessory) be installed near the point where the antenna cable enters the building or enclosure.

4.6 AC Power Wiring and Grounding

A standard three-conductor AC power cord is provided with the indoor mounting shelf for the

AC power connections. The receptacle end of the power cable connects to the AC connector on

the STM. The plug end of the power cable connects to a standard 120 VAC outlet. If AC power

spikes are likely to occur, a surge protector should be installed to protect the equipment from

damage. A grounding stud is provided on the left side of the mounting shelf for connecting a

separate grounding wire directly to the mounting shelf chassis.

4.7 User Interface

The RU mounting shelf user interface consists primarily of the mounting slots and AC and DC

power cables. The user interface points are indicated in Figure 2-6 and described in Table 2-3.

Figure 2-6. Remote Unit Indoor Mounting Shelf User Interface

18642-A

(1) STM MOUNTING

SLOT

(2) LPA MOUNTING

SLOT

(4) AC POWER

CABLE

(5) WDM

MOUNTING

SLOT

(6) CWDM

MOUNTING

SLOT

(7) CWDM DC

POWER CABLE

(3) GROUNDING

STUDS (INSIDE)