User Manual

ADCP-75-192 • Issue D • October 2005 • Section 2: Description
Page 2-19
 2005, ADC Telecommunications, Inc.
• FLT LED – Red LED lighted when module has failed or upon startup until the
module has been initialized. This light will blink after the module receives a system
clock and is awaiting initialization.
• PWR LED – Green LED lighted when module has power.
(4) FAULT LED
(3) P OWER LED
(1) ETHERNET
CONNECTOR
(2) IF CONNECTORS 1-8
Figure 2-13. Forward Simulcast Card Front Panel
Table 2-12. FSC User Interface
REF
No.
USER INTERFACE
DESIGNATION DEVICE FUNCTIONAL DESCRIPTION
1 Ethernet Connector RJ-45 connector Optional DIF signal input from alternate
source
2 IF Connectors 1-8 SMA connectors IF signal inputs from Full Band Hub Down
Converter module (only port 1 used)
3 Power LED Single-colored LED
(Green)
Status indicator turns green when module
has power.
4 Fault LED Single-colored LED
(Red)
Status indicator turns red when module has
failed. Indicator is lit during start-up until
the module has initialized. Indicator will
blink after module receives a system clock
and is awaiting initialization