User Manual

ADCP-75-192 • Issue D • October 2005 • Section 3: Network and System Installation and Setup
Page 3-28
 2005, ADC Telecommunications, Inc.
11.2.10 Setting The GPS Coordinates
transceptRanNodeGpsCoordTable.transceptRanNodeGpsLongitude
and
transceptRanNodeGpsCoordTable.transceptRanNodeGpsLatitude
For cases where a GPS receiver is not present on a given node and it is desired to manually
enter the GPS coordinates, the RAN Node MIB contains two MIB fields to configure the GPS
longitude and latitude settings. These MIB fields are bi-directional: the Digivance CXD
software (Hub Config Process) checks for the presence of a GPS on the RAN nodes - if the
GPS is present on a given node, then the GPS longitude/latitude values for that node will be
automatically populated from that RAN's Network Node MIB. If the GPS is not present, then
the values will be pushed to the Network Node MIB of that RAN node. When entering in the
GPS longitude and latitude values, the format is a string representing degrees as follows:
(-)xxx.yyyyyy, where the leading minus sign is optional.