User Manual

ADCP-75-192 • Issue D • October 2005 • Preface
Page iv
 2005, ADC Telecommunications, Inc.
TABLE OF CONTENTS
Content Page
3.4 CompactPCI Power Supply ....................................................... 2-16
4 HUB............................................................................ 2-16
4.1 Full Band HDC (FBHDC) ........................................................ 2-16
4.2 Forward Simulcast Module, FSC ................................................... 2-18
4.3 Hub Upconverter Module, HUC .................................................... 2-20
4.4 Reverse Simulcast Module, RSC ................................................... 2-21
4.5 Hub Reference Module, HRM ..................................................... 2-23
4.6 Ethernet Switch .............................................................. 2-25
4.7 BTS Interface Module, BIM....................................................... 2-25
4.8 Attenuator Shelf ............................................................. 2-26
4.9 Specifications ............................................................... 2-27
SECTION 3
NETWORK AND SYSTEM INSTALLATION AND SETUP
1 INTRODUCTION ..................................................................... 3-2
2 NETWORKING OVERVIEW .............................................................. 3-2
3 NODE IDENTIFICATION SCHEMES ......................................................... 3-3
4 IDENTIFICATION USING THE NETWORK IP RECEIVER/SENDER SYSTEM................................ 3-3
5 HUB EQUIPMENT IDENTIFICATIONS ....................................................... 3-3
6 ASSIGNING TENANTS ................................................................. 3-5
6.1 Understanding Tenant MIB Indexing.................................................. 3-5
6.2 BTS Connection MIB ............................................................ 3-6
6.3 Pathtrace Format .............................................................. 3-9
7 TENANT CONFIGURATION ............................................................. 3-12
7.1 Setting Protocol .............................................................. 3-12
7.2 Setting Channels ............................................................. 3-13
7.3 Setting Hub Measured Forward Gain ................................................ 3-13
7.4 Setting RAN Measured Forward Gain ................................................ 3-13
7.5 Setting FSC Gaunb ............................................................ 3-13
7.6 Setting RAN Forward Gain Offset ................................................... 3-13
7.7 Setting Reverse Gain........................................................... 3-14
7.8 Setting Forward Cable Loss ...................................................... 3-14
7.9 Setting Reverse Cable Loss ...................................................... 3-14
7.10 Using Tenant Reset............................................................ 3-14
7.11 Enabling FGC / RGC............................................................ 3-14
7.12 Using Tenant Mode ............................................................ 3-14
7.13 Enabling / Disabling Delay Compensation ............................................. 3-15
7.14 Setting Forward / Reverse Delay Skew ............................................... 3-15
7.15 Enabling / Disabling RAN slots .................................................... 3-15
7.16 Forward/Reverse Target Delay .................................................... 3-15
7.17 FSC Attenuator Offsets.......................................................... 3-16
7.18 Target Simulcast Degree ........................................................ 3-16