User Manual

ADCP-75-192 • Issue D • October 2005 • Section 2: Description
Page 2-22
 2005, ADC Telecommunications, Inc.
Each RSC module supports primary and diversity reverse DIF path summation and outputs
two (2) separate DIF signals.
(5) FAULT LED
(3) HOT SWAP
LE D
(4) P OWER LED
(1) DIF INP UT
LED 1-8
(2) DIF OUTP UT
LE D 1- 4
Figure 2-15. Reverse Simulcast Card Front Panel
Table 2-14. RSC User Interface
REFN
o.
USER INTERFACE
DESIGNATION DEVICE FUNCTIONAL DESCRIPTION
1 DIF Input LED 1-8 Multi-colored LED
(Green/Yellow/Red)
Indicator showing if no input signal (off),
good (green), degraded (yellow) or bad
data on channel (red).
2 DIF Output LED 1-4 Multi-colored LED
(Green/Yellow/Red)
Indicator showing if no input signal (off),
good (green), degraded (yellow) or bad
data on channel (red).
3 Hot Swap LED Single-colored LED
(Blue)
Status indicator turns blue when board can
be hot swap extracted. (Not used in CXD)
4 Power LED Single-colored LED
(Green)
Status indicator turns green when module
has power.
5 Fault LED Single-colored LED
(Red)
Status indicator turns red when module has
failed.