User Manual

ADCP-75-192 • Issue D • October 2005 • Section 2: Description
Page 2-17
 2005, ADC Telecommunications, Inc.
(3) FAULT LED
(6) P OWER LED
(2) IF2 AND TX2
CONNECTORS
(1) IF1 AND TX1
CONNECTORS
(4) IF3 AND TX3
CONNECTORS
(5) IF4 AND TX4
CONNECTORS
Figure 2-11. Full Band HDC Module
Table 2-11. Full Band HDC User Interface
REF
No.
USER INTERFACE
DESIGNATION DEVICE FUNCTIONAL DESCRIPTION
1 IF1 and TX1
Connectors
SMA connector Transmit input and IF output for band 1
2 IF2 and TX2
Connectors
SMA connector Transmit input and IF output for band 2
3 Fault LED Single-colored LED
(Red)
Status indicator turns red when module has
failed
4 Power LED Single-colored LED
(Green)
Status indicator turns green when module
has power.
5 IF3 and TX3
Connectors
SMA connector Transmit input and IF output for band 3
6 IF4 and TX4
Connectors
SMA connector Transmit input and IF output for band 4
The FBHDC allows use of adjacent channels for GSM and IDEN and W-CDMA.It also offers
unrestricted GSM frequency hopping. Channel tuning is not required, however band tuning is.
Four 20dB or 40dB attenuators are provided with each FBHDC. The attenuators allow a direct
or coupled connection from the BTS while restricting the FBHDC input range. 20dB is used
when coupled and 40dB is used when directly connected.