User Manual

ADCP-75-192 • Issue D • October 2005 • Section 2: Description
Page 2-10
 2005, ADC Telecommunications, Inc.
• FLT LED – Red fault LED lighted when module has failed lite upon startup until the
module has been initialized
• PWR LED – Green Power LED lighted when module has power
• HS LED – Hot Swap Blue LED, turns blue when board can be hot swap extracted
If this LED is lighted without the green PWR LED lighted then the hot swap
controller failed to initialize. Remove and reinstall module.
(7) SFP FIBER OP TIC
CONNECTOR
(6) FAULT LED
(4) HOT S WAP
LE D
(5) P OWER LED
(3) ETHERNET
CONNECTOR
(1) DIF INP UT
LE D 1-4
(2) DIF OUTP UT
LE D 1- 4
(9) OP TICAL INP UT LED
(8) OP TICAL OUTP UT LED
Figure 2-6. SIF Front Panel
Table 2-6. SIF User Interface
REFN
o.
USER INTERFACE
DESIGNATION DEVICE FUNCTIONAL DESCRIPTION
1 DIF Input 1-4 LED Multi-colored LED
(Green/Yellow/Red)
Indicator showing if the interface is not
enabled (off), good (green), degraded
(yellow) or no DIF tone lock or unused
channel (red).
2 DIF Output 1-4 LED Multi-colored LED
(Green/Yellow/Red)
Indicator showing if the interface is not
enabled (off), good (green), degraded
(yellow) or bad data on output of unused
channel (red).
3 Ethernet Connector RJ-45 connector
4 Hot Swap LED Single-colored LED
(Blue)
Status indicator turns blue when board can
be hot swap extracted. (Not used in CXD)
5 Power LED Single-colored LED
(Green)
Status indicator turns green when module
has power.