User Manual

ADCP-75-192 • Issue 1 • December 2005 • Section 3: Network and System Installation and Setup
Page 3-1
 2005, ADC Telecommunications, Inc.
SECTION 3: NETWORK AND SYSTEM INSTALLATION AND SETUP
Content Page
1 INTRODUCTION .................................................................... 3-2
2 NETWORKING OVERVIEW.............................................................. 3-2
3 NODE IDENTIFICATION SCHEMES ........................................................ 3-3
4 IDENTIFICATION USING THE NETWORK IP RECEIVER/SENDER SYSTEM ............................... 3-3
5 HUB EQUIPMENT IDENTIFICATIONS ....................................................... 3-3
6 ASSIGNING TENANTS ................................................................ 3-5
6.1 Understanding Tenant MIB Indexing ................................................. 3-5
6.2 BTS Connection MIB............................................................ 3-6
6.3 Pathtrace Format.............................................................. 3-9
7 TENANT CONFIGURATION............................................................. 3-13
7.1 Setting Protocol.............................................................. 3-13
7.2 Setting Channels ............................................................. 3-13
7.3 Setting Hub Measured Forward Gain................................................ 3-13
7.4 Setting RAN Measured Forward Gain ............................................... 3-13
7.5 Setting FSC Gain ............................................................. 3-13
7.6 Setting RAN Forward Gain Offset .................................................. 3-14
7.7 Setting Reverse Gain .......................................................... 3-14
7.8 Setting Reverse Cable Loss ...................................................... 3-14
7.9 Using Tenant Reset ........................................................... 3-14
7.10 Enabling FGC / RGC ........................................................... 3-14
7.11 Using Tenant Mode ........................................................... 3-15
7.12 Enabling / Disabling Delay Compensation ............................................ 3-15
7.13 Setting Forward / Reverse Delay Skew .............................................. 3-15
7.14 Enabling / Disabling RAN slots.................................................... 3-15
7.15 Forward/Reverse Target Delay.................................................... 3-16
7.16 FSC Attenuator Offsets ......................................................... 3-16
7.17 Target Simulcast Degree........................................................ 3-16
7.18 Module Attenuators ........................................................... 3-16
8 MANAGING THE TENANT OAM ADDRESS AND HOSTNAME TABLES ................................. 3-17
8.1 RAN Ordering ............................................................... 3-17
8.2 Bracketing of Lost RANs ........................................................ 3-18
8.3 Clearing of RANs ............................................................. 3-18
9 HUB NODE ACCESS/MANAGEMENT ...................................................... 3-18
9.1 Managing Hub Nodes .......................................................... 3-18
9.2 Identification using the Network IP Receiver/Sender ..................................... 3-18
9.3 Accessing Nodes Locally........................................................ 3-19
9.4 Accessing Nodes via TCP/IP ..................................................... 3-19
9.5 Using a Third Party Network Management System with Digivance CXD ......................... 3-20
10 CONFIGURING THE HUBMASTER NODE.................................................... 3-20
10.1 Utilizing The Configure-Hubmaster Script ............................................ 3-21
10.2 Using Dynamic Host Configuration Protocol with Digivance CXD ............................. 3-22