User's Manual

PN 8100-40 Help Hot Line (U.S. only): 1-800-530-9960 9-29
620004-0 Rev. B
Installing the Remote Access Unit
Connecting the UTP/STP Cable
Connecting UTP/STP to single band RAU:
Before connecting the UTP/STP cables, confirm that they meet TIA/EIA 568-A spec-
ifications (refer to Appendix B).
Connect the UTP/STP cable coming from the Expansion Hub to the RJ-45 female
jack on the RAU, as shown in the following figure.
Connecting UTP/STP cable to dual band RAU:
For the 900/1800 dual band RAU, connect the 900 MHz Expansion Hub cable to the
top RJ-45 jack and the 1800 MHz cable to the bottom RJ-45 jack.
For the 1800/1800 dual band RAU, connect the top (upper) 1800 MHz Expansion
Hub cable to the RAU’s top RJ-45 jack, and connect the bottom (lower) 1800 MHz
Expansion Hub cable to the RAU’s bottom RJ-45 jack.
The RJ-45 jacks on a dual band RAU are shown in the following figure.
Top RJ-45 female connector:
900/1800 dual band system: 900 MHz Expansion Hub cable
1800/1800 dual band system: top (upper) Expansion Hub cable
Bottom RJ-45 female connector:
900/1800 dual band system: 1800 MHz Expansion Hub cable
1800/1800 dual band system: bottom (lower) Expansion Hub cable