User's Manual

PN 8100-40 Help Hot Line (U.S. only): 1-800-530-9960 9-27
620004-0 Rev. B
Installing the Remote Access Unit
Installing RAUs using a Mounting Plate
You can install up to four RAUs using a Quad-RAU Mounting Plate (LGC Wireless
part number
MP-RAU-4).
Installing RAUs on the Mounting Plate:
After the Mounting Plate is securely installed, you can attach up to four RAUs to it.
• Slide an RAU into a Mounting Plate slot so the edge of the RAU meets the tab on
the Mounting Plate.
RAUs can be installed with either end against the tab.
Installing the Mounting Plate Above Ceiling Tile:
• Secure the mounting plate to the ceiling tile using the four screws.
Installing the Mounting Plate to the Wall:
1. Hold the mounting plate in position to the wall and mark the mounting plate’s
pre-drilled holes on the wall.
If installing the plate horizontally, make sure the supporting tabs are toward the
floor so the installed RAUs will rest against them.
2. Drill four holes in the wall where you marked.
3. Insert drywall anchors into the drilled holes.
4. Insert a screw through one of the holes in the mounting plate and screw it into one
of the drywall anchors.
5. Repeat step 4 for the other mounting holes.