User's Manual Part 2

Installing the LGCell
9-16 LGCell 4.0 Installation, Operation, and Reference Manual PN 8100-40
620004-0 Rev. E
9.2.5 Reporting LGCell Alarms to a Base Station
Report LGCell alarms to the base station by connecting the DIAGNOSTIC 1 port (see
“9-pin D-sub Connector” on page 3-7) on the Main Hub’s rear panel to the base sta-
tion’s alarm port.
Connecting a Single LGCell System’s Alarms to a Base Station
• Make a custom cable for this connection. See “9-pin D-sub Connector” on page
3-7 for the Main Hub’s alarm connector pin assignment.
Connecting Multiple LGCell System’s Alarms to a Base Station
Use the 5-port Daisy-Chain Alarm Cable (PN 4022-5), shown in Figure 9-6, to route
alarms from multiple LGCells to the base station.
Depending on the base station’s alarm connector’s pin assignment, you may need to
make a custom adapter cable in order to connect the LGCell alarms to the base sta-
tion.