User's Manual Part 2

PN 8100-40 Help Hot Line (U.S. only): 1-800-530-9960 9-15
620004-0 Rev. E
Installing the Main Hub
Connecting Two LGCells to a Base Station
1. Connect the DUPLEX, FORWARD, or REVERSE connector of one of the Main Hubs
to an input/output port on the power combiner/divider using an N-male to N-male
coaxial cable jumper.
2. Connect the DUPLEX, FORWARD, or REVERSE connector of the second Main Hub
to the second input/output port on the power combiner/divider using an N-male to
N-male coaxial cable jumper.
3. Connect the combined port of the power combiner/divider to an base station or a
repeater using an N-male to N-male coaxial cable jumper.
4. Check the Main Hub LEDs.
After connecting the LGCells, check all Main Hub LEDs to ensure that the system
is operating properly.
Connecting More Than Two LGCells to a Base Station
Repeat this procedure to connect any number of LGCell systems. For three systems,
use a 3x1 power combiner/divider, and so on.
NOTE: When you are connecting multiple LGCells to the FORWARD and REVERSE
simplex ports, you will have to use a power combiner/divider for each direction. Ter-
minate each unused power combiner/divider port with a 50 ohm terminator.