User's Manual Part 2

E-9
11
Enter the dial-up number (the PCARM modem number) that the remote ARM
will dial to establish communications with the PCARM. If you need to enter a
digit to access an outside line (such as 9), separate this digit from the phone
number with a comma for a pause. Enter 1 for long distance if required.
12
End the session by entering “AT H0 ”.
13
Exit HyperTerminal. You do not have to save the session.
PCARM Software Installation
To install the PCARM files
1
Place the PCARM disk in the A (or appropriate) drive.
2
Open Windows Explorer from the Program menu under the START Button.
3
Make directory PCARM under the C drive.
4
Make two sub-directories in the PCARM folder, labeled ARCHIVE and
BACKUP.
5
Exit Windows Explorer.
6
From the START Button RUN A:\PCARM.exe. Press OK.
The WinZip program will extract and unzip the PCARM files.
7
Save the unzipped PCARM files to the C:\PCARM directory.
8
Close the WinZip window.
9
Take out the PCARM disk and store in a safe place.
10
After you install these files, verify that the files are in the PCARM directory
via Windows Explorer, then exit Explorer.
To create a shortcut for PCARM
1
Right click the mouse on the Windows 95 desktop.
2
Place the mouse pointer over NEW.
Another menu pops up.
3
Click Shortcut.
4
Click Browse.
5
Double click PCARM.exe.
6
Click Next.
7
Click Next (again).
8
Double click the desired icon.
A “PCARM.exe” icon appears on the desktop.