User's Manual
Table Of Contents
- interWave WaveNet Link CX User Manual
- One - System Description
- 1-1 General
- 1-2 System Overview
- 1-3 Features
- 1-4 LinkCX Basic Structure
- 1-4.1 Radio Links
- 1-4.2 Data Stream
- 1-4.3 LinkCX Models
- 1-4.4 Mounting and Antenna Alignment
- 1-4.5 Interface Connectors and Indicators
- 1-4.6 Cables
- 1-4.7 Integral Antenna
- 1-4.8 External Antenna
- 1-4.9 Configuration, Operation, and Monitoring
- 1-4.10 SNMP
- 1-4.11 LinkCX Network Management Architecture
- 1-4.12 NMS Connectivity
- 1-4.13 Web-Based GUI Access Security
- 1-4.14 GUI Functions
- 1-5 Typical Applications
- 1-5.1 Internet (ISP)
- 1-5.2 Private Network Wireless Bridged LANs and WANs
- 1-5.3 PCS/PCN and Cellular Networks
- 1-5.4 Wireless Local Loop Networks and Local Exchange Bypass
- 1-5.5 Business Bypass and Local Exchange Bypass
- 1-5.6 Backhaul for Wireless MTU and MTU Access
- 1-5.7 Wireless Mesh Backhaul Networks
- 1-5.8 Wireless ATM Mesh Distribution with StreamNet
- 1-6 Specifications
- Two - Installation Steering Guide
- Three - Installation Planning
- Four - Installing the Link CX
- Five - Final Link CX Setup
- Six - Monitoring and Trend Analysis
- Seven - Troubleshooting the Link CX
- Appendix 1 - Interface Cable Pinouts
- Appendix 2 - Technical Specifications
- Appendix 3 - Using the Web-Based GUI User Interface
- Appendix 4 - Grounding and Lightning Protection
- Appendix 4 - Enterprise MIBs and Traps
Installing the Link CX 79
88 Go to the Test page and verify that the Link CX passes the tests in Table 4-11.
When all of the acceptance tests in this section have been completed and all Checklist items have been
verified, the Link CX radio link has been verified. The Inspector marks for all tested items constitute
acceptance of the Link CX equipment and the associated radio link.
Table 4-11 Internal Circuit and Radio Link Checklist
Checklist Item Verified Inspector Date
Does the Link CX input circuitry and DS-3/
Ethernet cabling work properly? (Set up Local +
Remote Loopback and verify that the DS-3/
Ethernet equipment is receiving the looped-back
signal it is transmitting to the Link CX.)
Does the Link CX radio circuitry work properly?
(Set up Radio Loopback and verify that the
DS-3/Ethernet equipment is receiving the
looped-back signal it is transmitting to the
Link CX.)
Do the near-end and far-end Link CX radio
circuits and radio paths work properly? (Set up
BER Test and verify that the near-end Link CX is
receiving the looped-back BER test signal it is
transmitting to the far-end Link CX.)
Does the end-to-end radio link work properly?
(Select No Test and verify that the DS-3/Ethernet
equipment at both ends of the radio link are
receiving the signal transmitted to it by the
remote DS-3/Ethernet equipment.)