User's Manual
Table Of Contents
- interWave WaveNet Link CX User Manual
- One - System Description
- 1-1 General
- 1-2 System Overview
- 1-3 Features
- 1-4 LinkCX Basic Structure
- 1-4.1 Radio Links
- 1-4.2 Data Stream
- 1-4.3 LinkCX Models
- 1-4.4 Mounting and Antenna Alignment
- 1-4.5 Interface Connectors and Indicators
- 1-4.6 Cables
- 1-4.7 Integral Antenna
- 1-4.8 External Antenna
- 1-4.9 Configuration, Operation, and Monitoring
- 1-4.10 SNMP
- 1-4.11 LinkCX Network Management Architecture
- 1-4.12 NMS Connectivity
- 1-4.13 Web-Based GUI Access Security
- 1-4.14 GUI Functions
- 1-5 Typical Applications
- 1-5.1 Internet (ISP)
- 1-5.2 Private Network Wireless Bridged LANs and WANs
- 1-5.3 PCS/PCN and Cellular Networks
- 1-5.4 Wireless Local Loop Networks and Local Exchange Bypass
- 1-5.5 Business Bypass and Local Exchange Bypass
- 1-5.6 Backhaul for Wireless MTU and MTU Access
- 1-5.7 Wireless Mesh Backhaul Networks
- 1-5.8 Wireless ATM Mesh Distribution with StreamNet
- 1-6 Specifications
- Two - Installation Steering Guide
- Three - Installation Planning
- Four - Installing the Link CX
- Five - Final Link CX Setup
- Six - Monitoring and Trend Analysis
- Seven - Troubleshooting the Link CX
- Appendix 1 - Interface Cable Pinouts
- Appendix 2 - Technical Specifications
- Appendix 3 - Using the Web-Based GUI User Interface
- Appendix 4 - Grounding and Lightning Protection
- Appendix 4 - Enterprise MIBs and Traps
78 Link CX User Manual, Version A
83 Verify that the electrical connections are correct. Use Table 4-10 to sign off the individual
checks.
The next series of acceptance tests requires you to log in to the built-in web server with a computer
equipped with a web browser.
84 Connect your computer to the Link CX through the Ethernet equipment connected to the
ETHERNET 1 or ETHERNET 2 port.
85 Log in to the Link CX built-in web server to display the Monitor page as described in
Section 4-2.2.
86 Make sure the Automatic Tx Power Control indicated in the lower half of the Monitor page is
set to Disabled.
87 Record the RSSI indicated at the top of the Monitor page. Save this number for later
troubleshooting.
Table 4-10 Electrical Connection Checklist
Checklist Item Verified Inspector Date
Is the proper voltage supplied to the Link CX
(PWR/LCL ALM LED on)?
Is the Link CX receiving signal from the radio link
(RF LINK LED on)?
When the Link CX is connected to DS-3
equipment, is the Link CX receiving the expected
signal (DATA LED on)?
When the Link CX is connected to Ethernet
equipment on port ETHERNET 1, is the Link CX
receiving the expected signal (ENET 1 LED on or
flashing)?
When the Link CX is connected to Ethernet
equipment on port ETHERNET 2, is the Link CX
receiving the expected signal (ENET 2 LED on or
flashing)?