User's Manual

60 UltraWAVE BTS Installation and Commissioning Guide, Release 6.5A
This action reboots the BTS. The VxWorks kernel is started, several E1 or T1 trunk card tests
run sequentially, and the results of each test are listed as PASSED/FAILED. Only if all seven
tests passed successfully will the E1 or T1 POST diagnostics be considered successful. The
E1 or T1 POST results will be displayed after the boot process has been completed:
3 The above display shows the E1 or T1 POST results that would appear if the E1 or T1 POST
diagnostics ran successfully on the E1 or T1 trunk card in slot 1. The format for each diag-
nostic line is:
[line number][action][E1 or T1 number][test number][test description][test result]
In the case of an error, a FAILED message would appear following the test that failed. In
addition, the following message would be displayed in Line 8:
E1 CARD in SLOT 1: COMPLETED POST/OFFLINE Test: FAILED
3-3.4 Verifying Telnet Communications with the BTS over Ethernet
The Craft PC uses telnet communications across the Ethernet connection for code downloads and to
use the proprietary Network Management Interface (NMI) for BTS testing. Before performing any of the
following procedures, ensure that you can establish and terminate a telnet communications session as
described in the following procedures.
The coding for the E1 or T1 trunk card, its modules and scripts
generically refer to the E1 or T1 trunk card objects as “E1”, whether the
corresponding ports are configured as E1 or T1.
1 (e1diag) E1 CARD in SLOT 1: STARTING POST/OFFLINE Test
2 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5
3 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5 result 0x0 i 1
4 (e1diag) E1(1) TID01: Initialize Peripheral Registers: PASSED
5 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5 result 0x0 i 2
6 (e1diag) E1(1) TID02: Peripheral Register Test: PASSED
7 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5 result 0x0 i 3
8 (e1diag) E1(1) TID03: Framer Register Test: PASSED
9 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5 result 0x0 i 4
10 (e1diag) E1(1) TID04: VME to CPU FIFO Flag Test: PASSED
11 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5 result 0x0 i 5
12 (e1diag) E1(1) TID05: Initialize Time/Space sw Chip: PASSED
13 (e1diag) testsPtr 0xffb33ab4 testsPtr[0] 0x5 i 6
14 (e1diag) E1 CARD in SLOT 1: COMPLETED POST/OFFLINE Test : PASSED
Figure 3-8 E1 or T1 POST Results
If an E1 or T1 trunk card fails the POST diagnostics, remove the failed
card and return it to interWAVE along with its test results file. The
defective card needs to be replaced with a new one, and POST
diagnostics should be run again on the new card.