User's Manual

50 UltraWAVE BTS Installation and Commissioning Guide, Release 6.5A
3-2 Off-Line Commissioning the UltraWAVE BTS
The verification procedures for off-line commissioning are run on the processor card in the BTS. Locate
the processor card in the baseband subrack assembly as shown in
3-2.1 Connecting the Craft PC to the ICP Processor Card
You will be making two connections from the Craft PC to the ICP processor card.The first is a
slow-speed serial connection used for checking the software version installed on the card, verifying
boot parameters and monitoring test results. The second is a faster Ethernet connection used for
opening telnet sessions with the ICP. Telnet sessions are required for downloading software to the ICP.
The serial and ethernet connections are both required to configure and test the BTS.
Required Hardware
The following hardware is required to connect the Craft PC to the ICP processor card through an
ethernet and serial connection. Note that this hardware is supplied with the Craft PC:
• one 3Com 3C589D PCMCIA Ethernet card with a 100/10-Base-2 combo transceiver
• one 3 meter standard RJ-11 patch cable
• one 3 meter standard Ethernet crossover cable
• one grey RJ-11 to DB9 adapter, part number 180247
Figure 3-1 BTS Processor Card
The following section describes procedures performed using the Craft
PC. For more information pertaining to the use of the Craft PC, please
refer to the interWAVE Craft PC Guide
.
Processor card
IW010301
ON
LINE
FLT
PWR
PORT 1
12
PORT 0
12
ALARMS
ALARMS
IIIIIIIIIIIIIIIIIIIIIIIII
P/N XXXXXX
IIIIIIIIIIIIIIIIIIIIIIIII
S/N XXXXXX
120 OHM
ONLINE
PWR
FLT
SCN
CON
ENET
IIIIIIIIIIIIIIIIIIIIIIIII
P/N XXXXXX
IIIIIIIIIIIIIIIIIIIIIIIII
S/N XXXXXX
PWR
DET
IN
ON LINE
FLT
RX-B
RX-A
13 MHZ
CLK
TX
OUT
PWR
DET
IN
ON LINE
FLT
RX-B
RX-A
13 MHZ
CLK
TX
OUT
PWR
DET
IN
ON LINE
FLT
RX-B
RX-A
13 MHZ
CLK
TX
OUT
PWR
DET
IN
ON LINE
FLT
RX-B
RX-A
13 MHZ
CLK
TX
OUT
PWR
DET
IN
ON LINE
FLT
RX-B
RX-A
13 MHZ
CLK
TX
OUT
PWR
DET
IN
ON LINE
FLT
RX-B
RX-A
13 MHZ
CLK
TX
OUT
012345678