User's Manual

42 UltraWAVE Micro BTS Installation and Commissioning Guide, Version B
Chapter 2 - Installation
3 Ensure the input power source is turned off and not supplying power to source
power connection.
4 Plug the power cable into the electrical mains or connect the flat washers,
shown in Figure 2-12, directly to the input power source, as follows:
 White is the neutral lead
 Black is the line lead
 Green is the ground lead
5 Plug the round quick disconnect connector as illustrated in Figure 2-12 into
the power connection on the top of the cabinet as illustrated in Figure 2-14.
Secure the connector by twisting the connector sleeve until the lines on the
cable connector and chassis connector align.
If you have ordered the NIB as separate subrack assemblies, you will connect
the input power cable directly to the power supply subrack assembly, shown
in Figure 2-11.
6 Do not apply power to the chassis at this time. Wait until you are
performing the off-line commissioning procedures in the next chapter.
Figure 2-13: AC Power Supply Module ON/OFF Switches
Power Switches
IW138603
INPUT
OUTPUT
FAULT
OFF
ON
UNLOCK
INPUT
OUTPUT
FAULT
OFF
ON
UNLOCK