User's Manual

12 UltraWAVE Micro BTS Installation and Commissioning Guide, Version B
Chapter 1 - Unpacking and Configuration Verification
1.4 Verifying and Documenting Cards and
Modules
The cabinet contains two subrack assemblies.
The Micro contains:
 RF modules responsible for RF power amplification, duplexing and
combining when required
 Processor Card, E1 or T1 trunk card, TRX cards, and clock module
The power supply consists of up to two power supply modules and a third slot
covered with a blank panel.
1.4.1 Required Equipment
To verify and record your system configuration, you need:
 A copy of the Shipping Checklist. It is one of the papers inside the shipping
container.
 A copy of Checklist 2 - Installation Checklist.
1.4.2 Micro Subrack Assembly
The Micro subrack assembly provides three RF slots, starting on the left with slot
A. Depending on your Micro BTS configuration, up to three slots will be required
for RF modules. These modules are shipped pre-installed and cabled from the
factory.
1 Locate the configuration part and serial numbers on your RF modules.
Figure 1-8 illustrates a sample of these labels.
2 Write down the part number, revision number and serial number in Checklist
2 - Installation Checklist.