Specifications

Reference Guide
C-13
Using the Control Terminal Port
The RS-232 Control Terminal Port allows you to connect the integrated access system to a
local VT100-compatible terminal, which you can then use to control the system. This port is
configured as a DCE interface.
Connect your local terminal to the TERM jack of the INF-E card. This is an RJ-48 jack in
compliance with EIA-561. Figure C-11 shows the pin locations on this jack, and Table C-9
lists the signal pinouts.
Figure C-11. RS232 (TERM) Local Interface Jack
Table C-9. RS232 (TERM) Jack Signal Pinouts
RS232 Pin Function Direction
4 Signal Ground N/A
5 Receive Data To local terminal
6 Transmit Data To access system
All other pins are unconnected.
Pin 1
Pin 8