Specifications

Reference Guide
7-51
WAN Card WAN Card User Screens and Settings
ELAP
The Elapsed time setting shows the running tally of the total number of seconds during the
test. Since this is an information-only field, there are no user-selectable parameters.
LB STATE
The Loopback State setting changes when a WAN unit is both present and operational. This
includes loopbacks caused by commands from remote devices as well as loopbacks caused by
local settings. The field will show
plb
(payload loopback) when the entire signal,
excluding
the framing bit,
is looped back. The field will show
llb
(line loopback) when the entire signal
is looped back. It will show
none
if the WAN port is not in loopback.
7.4.8 Adtran E1/HDSL Screen
Figure 7-34 displays the Adtran E1/HDSL Screen for the WAN-U card. To go to this screen,
press “
h
” (
Hdsl
command) in the WAN Card Main Screen. Table 7-17 lists the actions on the
bottom line of this screen, and Table 7-18 shows the screen options and defaults.
Figure 7-34. Typical Adtran E1/HDSL Screen
Node_1 | W1 H_E1+H_E1 Rev A0-0 Ser 00101 | 12-31-99 14:33
1 2
TRAIN MODE ltu ntu
LOOP off off
LOSS LP1 0 0
LOSS LP2 0 0
QLTY LP 1 loss loss
QLTY LP 2 10 10
LB STATUS none none
Save | Undo | Refresh | Perf | Main