Specifications

7-46
Reference Guide
Model No.
Running Head
WAN Card User Screens and Settings WAN Card
7.4.6 Far-End Performance Data
The Far-End Performance Data Screen is similar to the Performance Data Screen. The same
statistics are collected in a slightly different manner. Figure 7-32 shows a typical display of
far-end network register data in the AT&T mode. To view the far-end performance data, press
“
f
” (
Farstat
command) in the WAN Card Main Screen.
When
Farstat
is selected in the T1 AT&T mode, an FDL message is sent to the far end,
requesting the network register data from there. This data is displayed on the local terminal.
There will be a slight time delay in the data display.
When
Farstat
is selected in the ANSI T1.403 mode, the far end generates one-second
performance reports and sends them to the local system, where they are then stored.
To view E1 far-end statistics, you must select
c-sa4
as the COM/NMS RP setting.
Figure 7-32. Typical Far-End Performance Data Screen
Press “
c
” (
Clear
command) from the bottom line of this screen to send a FDL message to the
far end and also clear the local display. The following message will now appear:
“
Ok to clear performance (y/n)?”
Node_1 | W1 H_E1+H_E1 Rev A1-0 Ser 00101 | 12-31-99 14:33
Unit 1 AT&T FAREND STATISTICS NETWORK REGISTERS Sec. 240 of 900
ES UAS SES BES LOFC SLIP
CUR000000
01 ***** ***** ***** ***** ***** *****
02 ***** ***** ***** ***** ***** *****
03 ***** ***** ***** ***** ***** *****
04 ***** ***** ***** ***** ***** *****
05 ***** ***** ***** ***** ***** *****
06 ***** ***** ***** ***** ***** *****
07 ***** ***** ***** ***** ***** *****
08 ***** ***** ***** ***** ***** *****
09 ***** ***** ***** ***** ***** *****
10 ***** ***** ***** ***** ***** *****
11 ***** ***** ***** ***** ***** *****
12 ***** ***** ***** ***** ***** *****
TOTAL 000000
Retrieving message. Please wait...
Refresh | Clear | pgUp | pgDn | Main