Specifications

Reference Guide
7-33
WAN Card WAN Card User Screens and Settings
7.4.3 WAN HDSL Card Main Screen
Figure 7-28 shows the WAN HDSL Card Main Screen for PairGain T1/HDSL operation. This
example shows a WAN HDSL card with two PairGain T1/HDSL (821) modules. The
P-T1/P-T1 Modules for T1 operation have identical configuration parameters, which you must
set on the WAN Card Main Screen. To go to that screen select the desired WAN card on the
System Main Screen, then press <Enter>.
Figure 7-28. WAN HDSL Card Main Screen for PairGain T1/HDSL Modules
Table 7-9 lists several actions you can perform from the WAN HDSL Card Main Screen. These
actions appear in the bottom-highlighted line of the screen. To perform an action, simply press
the key corresponding to the uppercase letter of the desired action. For example, to save your
parameter settings, press “
s
” to invoke the
Save
commands. The only difference between Main
Screens for PairGain T1/HDSL operation is the addition of the HDSL action at the bottom of
the screen. The WAN HDSL Card only accepts PairGain T1/HDSL modules.
Node_1 | W2 P-T1+P-T1 Rev A1-0 Ser 00169 | 12-31-99 14:33
P-T1 P-T1
STATE stdby STATE stdby
MODE xcon MODE xcon
FORMAT esf FORMAT esf
LINE CODE b8zs LINE CODE b8zs
PULSE n/a PULSE n/a
LINE LEN 0 LINE LEN 0
SLIP LIM 126 SLIP LIM 126
AIS/ALM none AIS/ALM none
LINE LB n/a LINE LB n/a
LOCAL LB off LOCAL LB off
CH LB off CH LB off
LB ADDR 01 LB ADDR 01
LB GEN off LB GEN off
LB DET w/to LB DET w/to
ESF/NMS RP at&t ESF/NMS RP at&t
EER THRHD 10e-4 EER THRHD 10e-4
RDNT RULES none RDNT RULES none
GROUP none GROUP none
Save | Undo | Refresh | Xcon | Perf | Farstat | Test | Hdsl | Main