Specifications

7-28

Reference Guide

Model No.

Running Head

WAN Card User Screens and Settings WAN Card

7.4.2 E1 CEPT/HDSL Settings

Figure 7-27 shows the WAN Card Main Screen for E1 operation. This example shows a

WAN-U card with two Adtran E1/HDSL modules in system chassis slot W1.

Figure 7-27. WAN Card Main Screen for CEPT/HDSL

The WAN-U card only accepts Adtran E1/HDSL modules. The other WAN cards only accept

CSU or DSX/CEPT modules, which are described in the previous section.

The only difference between Main Screens for CEPT/HDSL operation is the addition of the

Hdsl

action on the bottom line of the screen and the top of the screen identifying slot W1

(H_E1+H_E1).

Table 7-7 summarizes the actions you can perform from this screen, and Table 7-8 lists the

CEPT/HDSL settings controlled on the screen along with their possible and default values.

Node_1 | W1 H_E1+H_E1 Rev A6-2 Ser 00101 | 12-31-99 14:33

H_E1 H_E1

STATE stdby STATE stdby

MODE xcon MODE xcon

FRAME crc FRAME crc

TS16 cas TS16 cas

EVEN BIT norm EVEN BIT norm

AIS/ALM none AIS/ALM none

LINE LB off LINE LB off

LOCAL LB off LOCAL LB off

CH LB on CH LB on

LB ADDR 01 LB ADDR 01

LB GEN off LB GEN off

COM/NMS RP none COM/NMS RP none

EER THRHD 10e-4 EER THRHD 10e-4

RDNT RULES n/a RDNT RULES n/a

GROUP none GROUP none