Specifications

7-18
Reference Guide
Model No.
Running Head
WAN Card User Screens and Settings WAN Card
7.4 WAN Card User Screens and Settings
7.4.1 T1 CSU and DSX Settings
The DSX/CEPT and CSU Modules for T1 operation have identical configuration parameters,
which you must set on, the WAN Card Main Screen. To go to that screen, select the desired
WAN card on the System Main Screen, then press <Enter>. Figure 7-23 shows a typical WAN
Card Main Screen for T1 CSU or DSX operation.
Figure 7-23. WAN Card Main Screen for T1 CSU and DSX
The headers of all WAN card screens show the types of modules installed on those cards. The
above example shows a WAN DUAL card with a CSU module on port 1 and a DSX/CEPT
module configured for T1 DSX operation on port 2. This card is installed in WAN card slot
W1 of the system. Its screen header designation is therefore
W1 CSU+DSX
.
The DSX/CEPT and HDSL modules also have identical parameters. These are described in
the next section of this chapter.
Table 7-3 lists several actions you can perform from the WAN Card Main Screen. These
actions appear in the bottom-highlighted line of the screen. To perform an action, simply press
the key corresponding to the capital letter of the desired action. For example, to save your
parameter settings, press “
s”
to invoke the
Save
commands.
Node_1 | W1 CSU+DSX Rev A6-2 Ser 00101 | 12-31-99 14:33
CSU DSX
STATE stdby STATE stdby
MODE xcon MODE xcon
FORMAT esf FORMAT esf
LINE CODE b8zs LINE CODE b8zs
PULSE n/a PULSE n/a
LINE LEN 133 LINE LEN 133
SLIP LIM 126 SLIP LIM 126
AIS/ALM none AIS/ALM none
LINE LB off LINE LB off
LOCAL LB off LOCAL LB off
CH LB off CH LB off
LB ADDR 01 LB ADDR 01
LB GEN off LB GEN off
LB DET w/to LB DET w/to
ESF/NMS RP at&t ESF/NMS RP at&t
EER THRHD 10e-4 EER THRHD 10e-4
RDNT RULES n/a RDNT RULES n/a
GROUP none GROUP none
Save | Undo | Refresh | Xcon | Perf | Farstat | Test | sWitch | pArs | Main