Specifications

Reference Guide
5-13
CPU Card TCP/IP Network Management
Table 5-5. TCP/IP Screen Option Settings and Defaults
HOST IP STATE
This parameter determines whether TCP/IP is active or inactive. This is the master switch for
the host IP stack, and is required to be set active in order for any IP communication to go
through. The HOST IP STATE defaults to
stdby
(standby) prior to configuration. You must
set it to
actv
(active) to enable TCP/IP.
HOST IP ADDR
The Host IP Address is the IP address for this specific system unit. If the B7R card is used for
this NMS, the Port IP address must be the same as the one entered in the
ADDR
field of that
card.
Action Function
Ping Test whether the connected device responds to an echo request message.
After entering the IP address of the host device, the status line will display,
"Testing . . ." The next message indicates if the host is alive or down.
Netstat Displays the Network Statistics. See below.
rOute Shows the Routing screen. See the “Routing” section below.
Save Saves changes to settings.
Undo Returns all settings to the last saved state.
Refresh Used on Testing and Monitoring screens to update statistics, and on other
screens to redraw the screen.
nX64 Used for nx64 kbps HDLC/FR connectivity to other Integrated Access
Systems as well as directly connecting to the MCC, IPR, FR at nx64 kbps.
Main Returns to the CPU card main screen. If changes are made to settings and
not saved, you will be prompted to save or lose changes.
Parameter User Options Default
HOST IP STATE stdby actv stdby
HOST IP ADDR IP address 0.0.0.0
HOST NETMASK Network 0.0.0.0
HOST TYPE host gateway host
DEFAULT IP PORT none local wan servr nX64 none
DEFAULT IP SLOT n/a local wan (w1, w2, w3, w4) servr
(P1, P2, P3) nx64
n/a
DEFAULT IP UNIT n/a 1-2 C1 C2 C3 C4 n/a
RPT1 IP ADDR IP address 0.0.0.0
RPT1 COMMUN STR blank
RPT2 IP ADDR IP address 0.0.0.0
RPT2 COMMUN STR blank
RPT3 IP ADDR IP address 0.0.0.0
RPT3 COMMUN STR blank