Specifications

4-40
Reference Guide
Model No.
Running Head
Assigning Time Slots System Configuration and Operation
4. Place an “
x
” under each desired time slot, using the space bar to either select or
de-select a time slot. Use the right arrow key to move to the next time slot (TS) for
selection. Then, press <Enter>.
In Figure 4-18 (for T1), the HSU port is assigned eight
time slots (9 to 16). In Figure 4-19 (for E1), the HSU port is assigned eight time slots (17
to 24).
5. Change the STATE of the port from
stdby
to
actv
.
6. Press “
s
” to save your settings.
Note:
In E1, time slots 0 and 16 are reserved.
Figure 4-18. Typical HSU Card Time Slot Assignments for T1
Node_1 | U1 HSU-366x2 Rev A04-0 Ser 01103 | 12-31-99 14:33
1 2
STATE stdby stdby
WAN/SERVER w1-1 w1-1
TS table table
RATE 64K 64K
Tx CLOCK int int
CLOCK PLRTY norm norm
DATA PLRTY norm norm
CTS perm perm
CTS DELAY 0 0
LOCAL LB off off
LB GEN MODE dds dds
LB GEN off off
LB DET w/to w/to
ISDN CONN no no
ERR off off
1 1 1 1 1 1 1 1 1 1 2 2 2 2 2
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4
x x x x x x x x
Save | Undo | Refresh | Copy | Test | Dial | Perf | Main