User`s manual

User's Manual

6. Front panel connections

6.1. Cat5 Connection 1

Cat5 cable carrying ADAT connections 1-4. Jacks “A” and “B” are electrically paralleled.

Depending on the number of jacks used, the push button “Termination” has to be set:

1 cable = “ON”, 2 cables = “OFF”. See also 8.1. Cat5 Termination.

NOTE: Redundant connections (the connection of two units with two cables over A and B at the

same time) are not supported! This would lead to signal loops causing undefined current flow.

6.2. Cat5 Connection 2 (ADX-64A-PRO only)

Cat5 cable carrying ADAT connections 5-8 and the wordclock signal. Jacks “A” and “B” are

electrically paralleled. Depending on the number of jacks used, the push button “Termination”

has to be set: 1 cable = “ON”, 2 cables = “OFF”. See also 8.1. Cat5 Termination .