User`s manual

User's Manual
11. SETTINGS OVERVIEW
Switch location Label Function ON
(upper position)
OFF
(lower position)
Front panel
“Cat5 Conn.1”
Termination Cat5 cable
termination
One cable connected to
“Cat5 Connection 1”
Two cables connected to
“Cat5 Connection 1”
Front panel
“Cat5 Conn. 2”
Termination Cat5 cable
termination
One cable connected to
“Cat5 Connection 2”
Two cables connected to
“Cat5 Connection 2”
Rear panel
“Cat5 Conn.1”
1 ADAT1+MIDI1
direction
ADAT1 and MIDI1
are outputs
ADAT1 and MIDI1 are inputs,
duplicated on “OUT/THRU” jacks
2 ADAT2 direction ADAT2 is output ADAT2 is input
duplicated on “OUT/THRU” jack
3 ADAT3 direction ADAT3 is output ADAT3 is input
duplicated on “OUT/THRU” jack
4 ADAT4 direction ADAT4 is output ADAT4 is input
duplicated on “OUT/THRU” jack
5 No function
6 No function
Rear panel
“Cat5 Conn.2”
(ADX-64B-PRO)
1 ADAT5
+Wordclock
+MIDI2 direction
When DIP-Switch 6 = “Multi”:
 ADAT5 and MIDI2 are outputs
 Wordclock jack outputs a
clock signal derived from
ADAT
When Switch 6 =”WC”:
 ADAT5 and MIDI2 are inactive
 Wordclock jack is output
When DIP-Switch 6 = “Multi”:
 ADAT5 and MIDI2 are inputs,
duplicated on “THRU” jacks
 Wordclock jack outputs a clock
signal derived from ADAT
When Switch 6 =”WC”:
 ADAT5 and MIDI2 are inactive
 Wordclock jack is input
2 ADAT6 direction ADAT6 is output ADAT6 is input
duplicated on “OUT/THRU” jack
3 ADAT7 direction ADAT7 is output ADAT7 is input
duplicated on “OUT/THRU” jack
4 ADAT8 direction ADAT8 is output ADAT8 is input
duplicated on “OUT/THRU” jack
5 Wordclock
termination
75 ohms termination active No termination
6 Channel 5 mode Multi: Channel 5 transmits ADAT
and MIDI data. A wordclock
signal derived from the ADAT
data stream is output on the
wordclock jack, regardless of the
direction setting.
WC: Channel 5 transmits a raw
wordclock signal. ADAT and MIDI2
on this channel is disabled. The
input / output function of the
wordclock jack must be set with
switch 1.
16