User guide

Reconnex Corporation
154
Release 7.0.0.4
3. Indicate the device on which you want the filter deployed. If you want to decide later,
you can check None.
4. Select the capture action you want the filter to perform.
5. Select the Port Element and Condition under Protocol.
Note: When you define a port or a port range, the system will return either a source or
destination port, but not both. To get a complete result showing both source and destination
ports, you must qualify your search by specifying the port used by both sender and recipient.
6. Enter the port or port range.
To view the latest update to the port list, go to http://www.iana.org/assignments/port-numbers.
7. Save.
8. Verify that the new filter is listed in the window that is launched.
9. Create the second port filter.